Recommended Mounting Hardware and Thickness of Optronics Trailer Reflector # RE35RB
Updated 02/08/2014 | Published 02/07/2014
Question:
What is the recommended mounting hardware for this reflector? Also, how thick is it?
asked by: Jake M
Helpful Expert Reply:
The screw hole of the Optronics Trailer Reflector, # RE35RB, is 1/4 inch in diameter. There is also a small lip that is 3/8 of an inch in diameter (see photo). Optronics does not recommend a specific type of fastener so you could use any type of screw you would like. I would recommend using a stainless steel screw because it will hold up the best against the elements.
This reflector is 0.22 inches thick, or just smaller than 1/4 of an inch.
Product Page this Question was Asked From
Screw Mount Reflector for Truck or Trailer - 2-3/16" Round - Red - Qty 1
- Trailer Lights
- Reflectors
- Round
- Surface Mount
- 2-3/16 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Questions About High Low Adapter For Travel Trailer
- Q&A: Slide Out Hitch Cargo Rack for a 2022 Winnebago Travato Motorhome
- Q&A: Hitch High-Low Extender Adapter for Use With Anti-Rattle Pin That Bolts in
- Q&A: Does GearSpace 34 Enclosed Cargo Carrier # HGK826 Come with Locks
- Q&A: What GearSpace Load Support will Fit My GearSpace 34 Cargo Carrier # HGK819?
- Q&A: Can I Add Swing Away Arm To Lets Go Aero GearSpace 34
- Q&A: What Does Let's Go Aero Landing Gear Cargo Carrier Load Support # H00550 Weigh
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements