Gear Kit for Sidewind Ram Brand Trailer Jack
Published 02/01/2023
Question:
I have two jacks that need new gear kits. Gears from both look identical but one jack I think this is a fulton has square holes 3/4inch x 3/4inch for the handle bushings and the other dont know the brand has square holes 5/8inch x 5/8. Which is the F0933302S00, and is there a kit for the other? Other than the handle bushing issue they look like the F0933302S00 will work in both.
asked by: Greg W
Expert Reply:
The jack on the left I can see is a Ram brand jack based on the faded sticker which means for a gear kit you'd need the part # TJA-2000S-GR. I can't ID the other jack from your picture though so if you can find a brand or label that would be helpful.
(click to enlarge)
Product Page this Question was Asked From
Replacement Gear Kit for etrailer and Ram Sidewind Jacks - 2,000 lbs and 5,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gears
- etrailer
more information >
Continue Researching
- Q&A: Comparing the Reese # RP500708 and Ultra-Fab Deluxe # UF17-943010 Landing Gear
- Q&A: Tie-Downs for 2026 Ford F-350 Long Bed With Factory Hitch
- Q&A: What Is The Thickness Of The Replacement Gear Kit For Etrailer And Ram Sidewind Jacks
- Q&A: Replacement Spring-Loaded Landing Gear Drop Leg Pull Pin with 3/8 Inch Diameter
- Q&A: Replacement Landing Gear Spring Loaded Pull Pins For Lippert 2-1/4" Landing Gear With 3/8" Pin
- Q&A: Recommended Tankless Replacement for Atwood Water Heater GC6AA-9E in 2000 Airstream
- Q&A: How to Find the Correct Replacement Lead Leg for 5th Wheel Landing Gear
- Article: Rooftop Cargo Carriers
- Article: Trailer Wiring Diagrams
- Article: How to Measure a Trailer Axle
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How Much Solar Power Do I Need For My RV?
- Article: How to Measure for Trailer Hitch Drop
- Article: The 5 Best Trailer Drop Hitches You Can Buy