How to Access the Pull Cord on a Thomas Payne Recliner For Replacement
Updated 05/29/2024 | Published 12/08/2022
Question:
I need to remove the Thomas Payne Classic Theater Seat in my rv so I can replace a broken pull cord. I have not found any information on how to remove the seat to expose the old broken pull cord.
asked by: Richard R
Expert Reply:
When replacing a Pull Cord for Thomas Payne # LC381462, the easiest way to get to the cord is to flip the seat over. This allows you access to disconnect the cord and remove the screws that hold the seat to the frame. Loosening the seat will allow you to access the bracket that holds the pull cord in place and install the new one.
Product Page this Question was Asked From
Replacement Pull Cord for Thomas Payne Heritage Theatre Seating Recliners and Love Seats
- Accessories and Parts
- RV Couches and Chairs
- Power Cords
- Thomas Payne
more information >
Continue Researching
- Shop: Replacement Pull Cord for Thomas Payne Heritage Theatre Seating Recliners and Love Seats
- Shop: etrailer RV Slide-Out Topper - 84" Wide - 4-Layer Vinyl - Black
- Shop: etrailer RV Slide-Out Topper - 138" Wide - 4-Layer Vinyl - Black
- Shop: etrailer Adapter Brackets for Solera Slide-Out Toppers - Qty 2
- Shop: etrailer RV Slide-Out Topper - 114" Wide - 4-Layer Vinyl - Black
- Video: Review of MAXXAIR RV Vents and Fans - Rooftop Vent with Pivoting Fan - MA36WV
- Shop: etrailer RV Slide-Out Topper - 132" Wide - 4-Layer Vinyl - Black
- Video: Review of Lippert Components RV Furniture - LC381462
- Shop: MaxxAir MaxxFan Rooftop Vent w/ Pivoting Fan - 4 Speed - Manual Lift - Smoke Lid
- Search Results: thomas payne accessories and parts
- Search Results: accessories and parts
- Search Results: trailer tool box
- Search Results: tailgate pad truck bed bike racks
- Video: Replacement Front Jack for Lippert Ground Control 3.0 Leveling System Review
- Video: Ultimate Overview of the Replacement Lead Leg for Keystone Montana 5th Wheel Landing Gear
- Search Results: rear suspension air bags
- Search Results: 301~036~00017
- Search Results: demco ez latch
- Shop: Truck Bed Bike Rack
- Q&A: Lippert Hydraulic Level Up Generation II Jacks For Towable RV Campers
- Q&A: What Would Cause Blue Ox Patriot 3 To Lock Up Vehicle Brakes?
- Q&A: Troubleshooting Blue Ox Patriot Vehicle Portable Braking System
- Video: Replacement Plastic Check Valve for B and B Molders City Water Inlet: The Breakdown
- Video: Westlake 215/75R17.5 Radial Trailer Tire Feature Review
- Shop: Brake Controller
- Q&A: Replacement Pull Cord For Reclining Feature on Thomas Payne Heritage Recliner or Loveseat
- Q&A: Will B&B Molders Replacement RV Plastic Check Valve Fit Nautilus P1 RV Water Control Panel
- Q&A: Replacement Pull Cables for Thomas Payne RV Recliners
- Q&A: How to Tell if Dometic 320 Full-Timer RV Toilet Will Fit RV
Grant G.
5/26/2024
I have a 2021 Grand Design 22 MLE with theatre seating (has a small flip up storage between them, cup holders, vibration and heat). The cable on the left seat either broke or got disconnected. The footrest is currently closed, or in the down position. When I looked at gaining access on the functional seat, I lifted the footrest and I can see the seat has two screws, front and back, that attach it to the frame. How do I access this on the non functional seat so that I can actually access the pull cord assembly to either reattach or replace? Thank you.