Dimensions of Inside Arch on Spring Seat for Typical 8,000-lb, Round Trailer Axles
Published 11/09/2022
Question:
Would like to know the measurement of the opening of the arch horizontallyinch if possible ?
asked by: Fred J
0
Expert Reply:
The Spring Seat for Typical 8,000-lb, Round Trailer Axles with 3-1/2" Diameter part # TRSS350 is designed for a 3-1/2" diameter axle so the opening of the cutout/arch is 3-1/2" which you can see in the photo below.
expert reply by:
Conner L
0
Dimensions of Inside Arch on Spring Seat for Typical 8,000-lb, Round Trailer Axles
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Spring Seat for Typical 8,000-lb, Round Trailer Axles with 3-1/2" Diameter
- Trailer Suspension Parts
- Spring Seats
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Round Axle - 3-1/2 Inch
- TruRyde
more information >
Continue Researching
- Q&A: Looking for Replacement Leaf Springs and Bearing Kit for 3,500 lb Trailer Axle
- Q&A: Should There Be a Washer on Trailer Spindle Between Spindle Nut and Outer Bearing
- Q&A: Type of Steel Used in TruRyde Trailer Leaf Spring TRSS350
- Q&A: Correct Front Hub Cover For a 2008 Fleetwood Southwind w/ 8 Lug 22.5" Wheels
- Q&A: Gooseneck Coupler That is Needed Longer Than 22 inches
- Q&A: Replacement Inner Member for TDE LP8500 Actuator
- Q&A: Solution for Lost Breakaway Pin for Trailer Breakaway System
- Article: How to Measure a Trailer Axle
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Most Popular Wheel Bearings
- Article: How to Tell the Weight Rating of a Trailer Axle