Are SeeLevel Sensors 710-AR & 710-ES2 Available

Question

Question:

Do you carry the 701AR and 701ES2 sensors

asked by: Ken H

0

Expert Reply:

We have the 710-AR and 710-ES2 SeeLevel sensors, though I was unable to find any 701AR or 701ES2. If you were referring to the 710-AR and 710-ES2 you would need the following:

- 710-AR: SeeLeveL Sensor # SE88VR

- 710-ES2: SeeLeveL Sensor # SE78VR

expert reply by: Kyle S

0

Answer 1

Hey Scott, This sensor is fully compatible with all monitors for reading 2, 3, or 4 tanks. It can read up to 7 tanks if your RV had the SeeLeveL Soul system installed from the factory. The sensor strip itself #SE78VR isn't the factor here,…

view full answer...

Answer 2

Yes, the SeeLeveL Sensors #SE27VR can be used on a tank mounted under a van. You'll just want to make sure that you cut the sensors to the correct length for the tank, and only cut in the specified points seen in the picture below. You'll…

view full answer...

Answer 3

Hey Bert, the biggest difference would be the Load Range which is a fancier way of saying the weight capacity. The Continental 235/75R17.5 HTR2 LRH has a Load Range of H whereas the Provider 235/75R17.5 LRJ is a Load Range J which means it has a…

view full answer...

Answer 4

Hello Bob, thanks for reaching out. We do offer a direct replacement for the 143701 motor on your 2007 Tiffin Allegro Bus. The correct replacement is the following: - Replacement Klauber F-350 Motor Assembly for RV Slide Out #LC52UD

view full answer...

Answer 5

Hey Skip, thanks for reaching out! Your Dometic thermostat is a single zone so you can either use the Black #DMC79FR or White #DMC95ZR thermostat as a replacement. These will be a direct replacement for your current thermostat so all of the functions…

view full answer...

Answer 6

Thanks for reaching out, Doran! The toggle switch for your FIC-ETJ3500 is pretty unique and it looks like for a direct replacement you'll need to reach out to FIC Jack Services directly at 1-877-957-1501. You might consider looking at and…

view full answer...

Answer 7

Hello Henry, thanks for reaching out. The Replacement Auto-Programmable Controller Panel #LC26TF is the correct replacement for your current Lippert part 366701. We have confirmed this directly with the folks at Lippert.

view full answer...

Answer 8

Hey Clayton, from what I can see the Replacement Sprayer Head for B&B Spinweld Sprayer #BM37ZR should just be attached to a fitting which you can pull off. That fitting it's attached to should then be attached to the black tank. The only…

view full answer...

Answer 9

Thank you for the pictures! I reached out to my contact at Dexter Axle who was able to confirm that you have #11 Torflex axles so the correct lift kit is part #K71-724-02. Since yours has top mounting holes you also need the bracket kit #DX57FR for…

view full answer...

Are SeeLevel Sensors 710-AR & 710-ES2 Available

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching