Why Does the Identification Light Bar for Trucks and Trailers Come with Extra Wire
Updated 09/20/2022 | Published 09/19/2022 >
Question:
Optronics sent me a link to ETrailer identifying the red identification light bar, MC- 93 RK/RB product. Do you think ETrailer has just the 3 light assembly without the wire harness? My trailer’s wiring for the MC-93RK/RB is just fine. All I will need to do is plug the light assembly and bolt it on to the trailer. Thank you in Advance,
asked by: Osmido I
Expert Reply:
The Identification Light Bar for Trucks and Trailers part # MC93RB comes with a bit of extra wire to leave you more room for your connections but if you are just replacing a light you'll just trim off the excess wire is all, it isn't available without this.
Product Page this Question was Asked From
Identification Light Bar for Trucks and Trailers - Weatherproof - Incandescent - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Light Bar
- Surface Mount
- Submersible Lights
- Incandescent Light
- 16L x 1-1/2W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Wiper Blade Recommendation For 2027 Kia Telluride EX Hybrid
- Q&A: Replacement ABS Hub for a Lippert 8,000 lbs Axle
- Q&A: How to Bleed Air from the Titan T43397007K Zinc-Plated Brake Actuator
- Q&A: What Lock Kit Is Needed For My B&W Pintle Hitch?
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Fireplace for a Furrion FF40SC15ABL
- Q&A: How to Install a Ventline Ventadome Roof Vent with 12 Inch Fan Powered Lift
- Q&A: Replacement 2-Way Connector Solution for NH Baler that Uses Non-Standard 2-Way
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Best Landing Gear
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle

