RV Window Latch Options  

I wasn't able to find the Atwood 36720 RV Propane Gas Detector you mention, however I was still able to find the RV Propane Gas Detector #RS64FR in white, or #RS44FR in black to work as a replacement for your Protechtor Series 2001 LP Gas…

The Atwood RV Carbon Monoxide and Propane Gas Detector part #AT36681 will be an excellent replacement for the ProTECHtor LP Gas Detector. The Atwood RV Carbon Monoxide and Propane Gas Detector has a seven year life span which is pretty standard. The…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The ideal height will actually have to do with how tall the coupler of the trailer is from the ground. The Draw-Tite #76020 will sit at 13 1/2 inches from the ground to the top of the hitch when installed on a 2016 Mazda CX-9. From what I could find…

Yes, it can! To add a 2" hitch ball to the Curt Pintle Hook with 2-5/16" Ball item #C45910-15-20 you'll need the Replacement Hitch Ball for Curt Pintle Hook Combo item #C48820. This is the only way to add a 2" hitch ball you…

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

To add an anti-rattle device to the Curt Adjustable 2-Ball Mount #C99NR I highly recommend the Roadmaster Quiet Hitch #RM-061 simply because it's a tried-and-true solution that's easy to use and still very effective. The Quiet Hitch…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…

Since your 2024 Ford F-350 does not have the factory 5th wheel prep and Reese does not offer an under bed rail kit at this time(5/22/2024) you are going to have to install a standard 5th wheel Rail Kit #C26ZV. Then you will be able to use the Curt…