Height of the Timbren Rubber Spring in the Timbren Suspension System # TGMRSB4
Updated 11/18/2013 | Published 11/16/2013
Question:
My suburban is a 94 and I am going to be pulling a small trailer with it. My concern is that being so old my springs may have a certain amount of sag already from age which may crowd the springs space. Could you let me know the height of the springs in my kit so I can make sure I will have the 1 inch space once I instal .. thanks.
asked by: Kevin S
Helpful Expert Reply:
I spoke to my contact at Timbren and she informed me that the height of the rubber spring is 4-3/4 inches plus the thickness of the plate which is 1/4 of an inch.
You should note that suspension enhancements are designed to work on vehicles with functioning suspension, if your suspension is worn out I would not recommend you use this system on your vehicle.
Product Page this Question was Asked From
Timbren Rear Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Standard Duty
- Rear Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Differences Between Tekonsha 90885 Prodigy P2 and BRAKE-EVN TK63VR Brake Controllers
- Q&A: Best Brake Controller for a 2022 Jeep Gladiator with Tow Package
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can I Pull A 5th Wheel Camper With A Chevy Colorado?
- Q&A: Air Bag Helper Springs for a 1995 Chevy Suburban 1500 4x4
- Q&A: What is the Difference Between the Tekonsha Prodigy P2 and the P3 Brake Controllers
- Q&A: How to Install a Brake Controller on a 1999 GMC Suburban