Difficult to Install Plunger of Roadmaster Breakaway Switch
Published 08/24/2022
Question:
Roadmaster breakaway switch key was pulled out by automatic car wash. Is there a trick to reing the key? Only seems to go in half way. Thank you
asked by: Brian S
0
Expert Reply:
The switch can be somewhat difficult to fully seat in the housing but basically you just have to make sure the switch # RM-200200-20 is lined up properly and then apply firm pressure to get it to go all the way in.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Breakaway Switch Key for Roadmaster Even Brake and Brake Pro Flat Tow Brake System
- Accessories and Parts
- Flat Tow Brake System
- Breakaway Kit
- Switch Key
- Roadmaster
more information >
Continue Researching
- Q&A: Can Oil Cap RG04-230 be Used as Grease Cap
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Transmitter For Roadmaster Even Brake Portable Supplemental Braking System
- Q&A: Should Equalizer and Shackles Be Replaced After Being Shoved Out of Position
- Q&A: Determining The Correct Replacement Equalizer And Shackle Straps For A 2017 Forest River 5th Wheel
- Q&A: Gooseneck Hitch Solution for 1976 Ford F-250
- Q&A: What Types of Accessories Are Designed to Fit Top Channel of Thule Wingbar Evo
- Q&A: Replacement Gear Kit Instructions and Diagram for Ram 12,000 Series
- Article: Flat Towing Package for 2002-2004 Jeep Liberty
- Article: Trailer Wiring Diagrams
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Stability Control for Heavy Duty Vehicles