Replacement Wobble Rollers for 1999 Magic Tilt Boat Trailer  

That is correct, Andy. The only difference between the Square 2-Speed Jack w/ Crank #TJD2SP-12000SP-F and the Square 2-Speed Jack #e26FV is that #TJD2SP-12000SP-F includes the handle and #e26FV does not. You'd have to purchase it #TJD-12000-HD…

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

The biggest difference between the servo styles that you'll notice is between free backing plates and the others. The free-backing plates will allow your trailer to back up without having the brakes lock up. With surge brakes typically when you…

You will have to go out and measure the rollers you have on your trailer if you are looking for an exact replacement to use. You will want to measure the overall diameter of them plus the diameter of the hole that runs down the middle of them. For…

The Mounting Bolt #7-75 that comes with the Kit #BRKH10A for 10" brake assemblies is a grade 5 bolt.

Thanks for the picture! To replace your Yates 530R you'll need the #YR530R-6P for a direct replacement, or if you're wanting to upgrade to an option that won't mark your boat the #YR500YW-6P you had looked at would work perfectly as well.…

In order to find the correct ribbed rollers for your boat trailer, you will need to measure the diameter of the shaft on the roller bunk assembly. For example, the CE Smith Ribbed Wobble Rollers #CE29210 fit both 3/4" and 1-1/8" roller…

It really depends on the springs used. Take a look at the picture I have included that shows hanger spacing based on several different springs. This will be a good guide to reference when mocking up the suspension on your trailer. This is also found…

The only wobble roller that we have which fits a 1" shaft and doesn't have a 5" diameter is the CE Smith #CE29539. This wobble roller has a 4-1/4" diameter and measures 3" wide. If you need it to have a larger diameter than…