Does Curt Trailer Hitch Receiver Fit 2010 BMW 128i Convertible
Updated 07/20/2022 | Published 07/18/2022
Products Featured in This Question
Question:
Does the C11184 hitch/receiver fit the 2010 BMW 128i CONVERTIBLE, and if so, are there any different install instructions?
asked by: John H
Helpful Expert Reply:
It does! I verified for you with the manufacturer that the Curt hitch does indeed fit your 2010 BMW 128i convertible and the installation instructions will be the same. The correct part number is the following:
- Curt Trailer Hitch Receiver # C11184
This will work perfectly for you and if you are using it for an accessory like a bike rack, it's all you need. But if you plan on doing some light towing with the hitch, you'll also need the following for a complete towing set up:
- Vehicle Wiring Harness Kit # 119250KIT
- Curt Class II Drawbar # C45521
- Pin and Clip # F-4
- 2" Hitch Ball # C40018 or 1-7/8" Hitch Ball # C40001
Product Page this Question was Asked From
2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Chrome - 3,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 3500 lbs GTW
- 2 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 3/4 Inch Diameter Shank
- CURT
more information >
Continue Researching
- Q&A: Is The Curt Hitch Or The Draw-Tite Hitch Better For A 2025 Mazda 3 Sedan?
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Q&A: Which Hitch Fits a 2015 Toyota Prius Plug In Hybrid
- Q&A: Replacement Parts for Suburban Model SW6 DE Water Heater
- Q&A: 7-Way RV Trailer Connector Wiring Diagram
- Q&A: Trailer Wiring Harness Installation on 2015 Subaru Impreza
- Q&A: Visibility of the Curt Class I Hitch on a 2009 Volvo S40
- Q&A: Recommendation for 1-1/4 Inch Ball Mount with 8 Inch Rise
- Article: Trailer Lighting Requirements
- Article: What Do I Need To Tow A Trailer?
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: How to Choose the Right Trailer Hitch Class
- Article: Performance Chips and Modules