Can 7.2k Axle Trailer Hub Be Replaced with 8k Trailer Axle Hub
Published 05/26/2022
Question:
Can I replace the 7.2k wheel end with 8k wheel ends?
asked by: Jason S
0
Expert Reply:
Trailer hubs that are designed to fit 7.2k axles and 8k axles use the same size spindle so if you wanted to go with an 8k hub in place of your 7.2k hub you certainly could like with the # 8-285-11UC3 which has an 8 on 6-1/2 inch bolt pattern with 9/16 inch diameter wheel studs.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter Trailer Hub and Drum Assembly for 8,000-lb E-Z Lube Axles - 12-1/4" - 8 on 6-1/2
- Trailer Hubs and Drums
- Hub with Drum
- EZ Lube
- 25580 / 02475
- Standard Grade
- For 8000 lbs Axles
- 9/16 Inch Stud
- 8 on 6-1/2 Inch
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- 17 Inch Wheel
- 17-1/2 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Q&A: Are Double Eye Leaf Springs Rated For 8,000 lb Axles
- Q&A: Does the Lippert Hub and Drum Assembly LC57DX Take a Threaded Grease Cap?
- Q&A: Replacement Brake Assemblies for Dexter 023-358-00 Trailer Brakes
- Q&A: How to Determine Correct Replacement Ceramic Kodiak Brake Pads
- Q&A: Can Dexter 8k Axle Work with Hub Centric Wheel with 4.75 inch Pilot Diameter
- Q&A: Replacement Oil Seal for AL-KO 568303
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Slipper Spring Trailer Suspension System Review
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Can You Flat Tow a Ford Escape?
- Article: Most Popular Wheel Bearings