Dimension of Redline Bolt-On Spring Latch # SL716
Updated 10/02/2013 | Published 09/24/2013
Question:
What is the measurement from the bottom of the base up to the center of the pin?
asked by: Jim
0
Expert Reply:
The base of the # SL716 Spring latch to the center line of the pin measures exactly 13/16 of an inch, as you can see in the diagram I have edited for you.
expert reply by:
Mike L
0
click to enlarge
Product Page this Question was Asked From
Continue Researching
- Shop: Bolt-On Zinc Spring Latch
- Video: Ultimate Overview of the Bolt-On Zinc Spring Latch
- Search Results: gate latch pin
- Q&A: Length of Exposed Part of Pin when Pulled All the Way Out on Bolt-On Zinc Spring Latch # SL716
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Distance Between The Mounting Tabs On A The Roadmaster Direct-Connect Base Plate Kit # 1437-3
- Q&A: Attaching Tow Bar to 2010 Jeep Wrangler With Rugged Ridge Bumper
- Q&A: Will the Demco 5-Position Adjustable Channel Bracket Fit a Boat Trailer
- Q&A: Hardware Typically Used to Install A-Frame Trailer Jack
- Q&A: Replacement Brake Assemblies for Dexter 023-358-00 Trailer Brakes
- Q&A: Tie Down LP7000 Brake Actuator Replacement
- Article: Trailer Lighting Requirements
- Article: Rooftop Cargo Carriers
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Raise Your Travel Trailer Height
- Article: Adding Electric Over Hydraulic Disc Brakes