How to Mount Optronics Thin-Line LED Racing Light Kit # LS-108

Updated 09/20/2013 | Published 09/18/2013

Question:

Do I take it that I would mount the black bracket you showed the other gentlemen that you measured the center to center hole at 2 3/4inch on the LS 108s and I would pop the LED lights into these black brackets from the front. [Cant see the back mount of the black bracket]. do you guys sell ay other flexible LED lights similar to the 104s or the 108s as I want to mount these just below bumper [kind of in the grill] and the line I want to use has a slight bend and these are straight and will look a little funky[putting 4 in a row per side] with straight lines making a curve. Thanks for your fast response P.S. as they are going on front grill are they quasi waterproof for rain or car washing purposes?

asked by: Mike C

Expert Reply:

The Optronics Thin-Line LED Racing Light Kit, part # LS-108, mounts using included brackets and hardware. The black metal mounting brackets attach to the vehicle with supplied sheet metal screws; the center-to-center spacing of the mounting holes is 2-3/4-inches. The light fixtures themselves attach to the brackets with a Philips screw on each end of the light housing. These decorative lights are not fully waterproof; they have a 2-piece housing that is not permanently sealed but which will provide some degree of resistance to moisture.

If you need a flexible waterproof LED light to fit on the curved mounting surface on your vehicle we do offer several. For example, CIPA offers a 15-inch 9-LED version, part # CM93296. Blue and red LED versions are also available.

expert reply by: Adam R