Installation of Redline Pre-Drilled Round Rubber Trailer Bumper
Published 04/22/2022
Question:
Got the rubber bumper yesterday they say 5/8inch bolts are required why cannot i use 3/8inch bolts as that is a lot of drilling for the larger bolts
asked by: Dave
0
Expert Reply:
The Rubber Trailer Bumper, # D4-96 comes from the manufacturer with recommended guidelines for best fitment their product. If you choose to alter the installation from recommended that is your choice, but it may not hold up the way it was designed with the improper hardware.
expert reply by:
Michael R
0
Product Page this Question was Asked From
Pre-Drilled Round Rubber Trailer Bumper - 96" Long x 4" Wide
- Trailer Door Parts
- Ramp Door Bumpers
- Bumper Strip
- Bolt-On
- 4 Inch Wide
- 96 Inch Long
- Rubber
- Redline
more information >
Continue Researching
- Q&A: How Wide is the Curt Weight Distribution Shank C17132?
- Q&A: Will Round Rubber Trailer Bumper Fit Trailer With 12 Inches Between Mounting Holes
- Q&A: Replacement Motor for Klauber Slide Out Motor K01431B300
- Q&A: Can I Extend My Hitch Without Using TorkLift Hitch and SuperTruss Extension
- Q&A: Replacing Norcold N410 Mini RV Fridge With Everchill RV Mini Fridge
- Q&A: Overall Length and Socket Size for 1/2"-20 Taskmaster Trailer Wheel Lug Nut
- Q&A: Air Distribution Box and Thermostat for 15K Btu Advent Air R32 AC Unit
- Article: Trailer Maintenance Schedule
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Tester Battery Replacement for Part Number 8010