Fitment of C-Shape RV Cabinet Drawer Slide Socket Set
Updated 04/04/2022 | Published 04/03/2022
Question:
How can i fit the track in the socket? Do i need to heat it to make it plyable? It is too small to fit with just my force.
asked by: Judy J
0
Expert Reply:
Please verify the needed measurements for your application and ensure you have purchased the correct item. The RV Cabinet Drawer Slide Socket Set, # 37270735 that we carry is 7/16 and 1 inch width dimensions as per inside dimensions. Please review the linked video as you will see these dimensions as well as more info.
expert reply by:
Michael R
0
Product Page this Question was Asked From
RV Cabinet Drawer Slide Socket Set - C-Shape - 2-3/8" Deep
- RV Cabinet and Drawer Hardware
- Drawer Hardware
- Slides
- JR Products
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Availability Of Replacement Rod And Nut For Lippert Ground Control 3.0 Jack Leg
- Q&A: Can I Use an Adapter to Plug the 30 Amp ActiveStart Plug-In Soft Start to a 50 Amp Plug?
- Q&A: Replacement Gas Detector for an Atwood Series 2001 LP Gas Detector
- Q&A: Correct Replacement Circuit Board for the MaxxFan 4401K Roof Vent
- Q&A: Replacement Drawer Slide Socket Options Available
- Q&A: Wiring Diagram for Lippert Stabilization Jack LC298707
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Q&A: Looking For Trim Molding For 2000 Skyline Layon Model Trailer
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps