Recommended Running Board For A 2011 Chevrolet Silverado 2500 HD
Updated 03/23/2022 | Published 03/19/2022
Question:
Could the Carr Custom-Fit Side Step - Hoop II be fastened to running board on Chevy 2500 HD. Wife had hard time getting in higher truck with aging knees and needs additional lower step. Thanks for any info
asked by: Edwin E
Expert Reply:
I do have a solution for you. Unfortunately, it will not be the Carr Custom-Fit Side Step - Hoop II - Black Powder Coated Aluminum - 7" Step - Qty 1, part # CARR103991-1. You cannot attach this Carr Side Step to the running boards on your 2011 Chevrolet Silverado 2500 HD. The only option we have would be a motorized running board that lowers when the doors of your truck open. It would require that you remove your existing running boards.
If you have the extended cab, the Bestop PowerBoard Motorized Running Boards with LED Lights, part # B7514715, will fit your vehicle.
This motorized step has up to 9" of drop I have included product description links below.
Product Page this Question was Asked From
Carr Custom-Fit Side Step - Hoop II - Black Powder Coated Aluminum - 7" Step - Qty 1
- Nerf Bars - Running Boards
- Side Steps
- 3-1/2 Inch Wide
- Matte Finish
- Fixed Step
- Aluminum
- Black
- Carr
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Need To Replace Dometic Awning MFR 916FT.21 501UL PNC 958603680
- Q&A: Is there Any Steps for My 1976 Chevrolet K5 Blazer that do Not Require Drilling to Install?
- Q&A: What Is A Good Adapter To Go From My 2 1/2 Hitch To A 2 Inch?
- Q&A: Where To Find The Factory Brake Controller Wire Harness In A 2023 Ford F-150
- Q&A: Comparing Hollywood Racks Sport Rider SE and RV Rider Bike Rack
- Q&A: Will the RockyMounts Backstage fit Electric Bikes with Fenders?
- Q&A: 1998 Ford E-350 Cargo Van Floor Mat Recommendation
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Rooftop Cargo Carriers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Brake Controller Installation: Starting from Scratch