How to Ground an LED Trailer Light to a Trailer with a Fiberglass Body
Updated 08/23/2013 | Published 08/22/2013
Question:
My RV siding is fiberglass. How will I ground the L.E.D. clearance light?
asked by: Larry
0
Expert Reply:
What you would need to do is run a jumper ground from the grounding point on light # MCL75AB to a metal location nearby. You can use the frame or a metal support structure if available. This may require some additional work because you will have to route a wire somewhere for the ground but it will work out just fine.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Optronics ThinLine LED Trailer Clearance and Side Marker Light - Submersible - 4 Diodes - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 4L x 1W Inch
- Amber
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Does etrailer Sell The Rubber Bumper For Trailers D4-96 ?
- Q&A: What Slide-Out Actuator will Replace My Kwikee with Part Number 907202104?
- Article: Trailer Lighting Requirements
- Q&A: Replacement Fender Light With Part Number 1A-V-1260AR
- Q&A: Recommended Center Cap for a Aluminum AM03 Series Black Machined Trailer Wheel
- Q&A: Firestone Ride-Rite Air Bags F37XV for 2018 Ram 3500 4 Wheel Drive Dully
- Q&A: Gooseneck Hitch Recommendation for 2008 Chevy Silverado 3500HD Service Body
- Q&A: Available Trailer Brake Assemblies Compatible With Lippert 122460 3500 LB Capacity Hub/Drum
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Wiring Diagrams
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Most Popular Wheel Bearings