Troubleshooting a Stuck Valterra Extension Rod for a RV Waste Valve
Updated 03/15/2022 | Published 03/14/2022
Products Featured in This Question
Question:
My backwater tank has a valterra valve the rod is bent a little bit so it makes it kind of hard to push it in and out does the whole valve need to be replaced or does the rod unscrew from the paddle and you can screw a new one in I would appreciate that help
asked by: Richard M
0
Product Page this Question was Asked From
Valterra Waste Valve Extension Tube with Handle - 8"
- Accessories and Parts
- RV Waste Valves
- Waste Valve Parts
- Handles
- 8 Inch Long
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Motor for Kwikee 32 Series Steps on a 2002 Eastwood Discovery
- Q&A: Replacement Rubber Plug for Top of Bulldog 4k Powered Trailer Jack
- Q&A: Replacement Components For A Schwintek Slide Out System
- Q&A: Recommended Replacement For A Marshall 605H LP Regulator
- Q&A: Are Spacers in 5th Wheel Installation Kit RP50082-58 Required for Installation
- Q&A: Replacement Range Hood Motor for Ventline Model PH CC0431-09
- Q&A: Replacement for Furrion Female Twist Lock 50 Amp Connector
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: How to Hitch and Lock a Trailer
- Article: Gooseneck to 5th Wheel Adapters