What Prevents Camco Cam Lock # CAM44323 From Turning
Updated 03/09/2022 | Published 03/08/2022
Question:
what about the two sides that are straight, to keep the lock from turning. if you make a 5/8 round hole it will turn?
asked by: JULIE P
0
Expert Reply:
The two flat sides of the threaded portion of the Cam Lock part # CAM44323 are designed to prevent it from turning. If you were to drill a totally round hole this would turn unless it was tightened down a lot.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Camco Cam Lock - Straight or Offset - Thumb Operated - 3/4" Thick
- RV Door Locks
- Compartment Door
- Cam Locks
- Offset Cam
- Straight Cam
- 7/8 Inch Long
- Silver
- Camco
more information >
Continue Researching
- Q&A: Weight Distribution Hitch for 2026 Chevy Silverado 3500 Towing Brinkley Z Air 297
- Q&A: Thumb Latch Cylinder Measurements
- Q&A: Is Intelli-Power Converter PD9260C Lithium Compatible?
- Q&A: Can Camco RV Baggage Door Catches be Used on a Pop Up Camper's Door
- Q&A: Replacement Key for Compartments on 2006 Georgie Boy Pursuit Motorhome
- Q&A: Troubleshooting a Demco Stay N Play Duo that Won't Activate the Brakes
- Q&A: Looking for Mounting Kit for 2-30 lb RV Propane Tanks
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Trailer Maintenance Schedule
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: How to Drain an RV Water Heater