What Center Cap Fits the Taskmaster Steel Wheel # TA83VR?

Question

Question:

What cap works with the Taskmaster Steel Modular Trailer Wheel - 16" x 6" Rim - 8 on 6-1/2 TA83VR?

asked by: Andres

0

Expert Reply:

For the Taskmaster Steel Wheel # TA83VR, I recommend the Americana Trailer Wheel Center Cap - 5.12" - Chrome # AM90083. This cap fits the Taskmaster's 5.12 inch pilot diameter. Also, the cap removes easily to still allow access for hub maintenance.

expert reply by: Bob C

0

Answer 1

We do have the Lionshead Trailer Wheel Center Cap #LHCS102-SI60C that will fit the 15" 5 on 4.5" Vesper Steel Modular Trailer Wheel #MX34FR with 3.19" pilot hole. We also have hub covers in Black #PXQT545BHS and Chrome #QT545C if you…

view full answer...

Answer 2

Yes, the #84556UC3-EZ is the correct hub and drum assembly and the #23-26-27 will work for brakes. However, you might want to consider the Dexter Nev-R-Adjust #23-468-469 for brakes instead. Since they are self-adjusting, you won't have to worry…

view full answer...

Answer 3

The largest pilot hole opening on our 15" trailer wheels with a 5 on 5" bolt pattern is 3.19", like with the Dexstar Steel Spoke Trailer Wheel #AM20428. This is really the standard pilot hole dimension for this size wheel. Keep in mind…

view full answer...

Answer 4

Thanks for that detailed info and there is a cover that will work for you, though the 15 foot length you mentioned is the total length, including the tongue/coupler, and covers are not meant to go over that part of the trailer. I looked up your…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

What Center Cap Fits the Taskmaster Steel Wheel # TA83VR?

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching