How Far Apart are the Holes on the Replacement Bottom Mounting Clamp for Thule Ride-On Adapter
Updated 07/31/2013 | Published 07/29/2013
Question:
How far apart are the holes in the Thule Bottom Mounting Clamp for the Ride on Adapter?
asked by: Dan S
0
Expert Reply:
On the Thule replacement mounting clamp bottom piece, # 753-2854, it will fit around crossbars that are up to but not exceeding 3-3/4 inches wide. The holes are approximately 3-1/2 inches apart on center.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Replacement Bottom Mounting Clamp for Thule Ride-On Adapter, Snowboard Rack and Flat Top Ski Carrier
- Accessories and Parts
- Ski and Snowboard Racks
- Clamps
- Ride-On
- Thule
more information >
Continue Researching
- Q&A: Replacement Bracket for Thule Flat Top Ski and Snowboard Carrier TH91725
- Q&A: Will Mounting Kit for Thule Flat Top Rooftop Ski and Snowboard Racks Fit Haul-Master Roof Rack
- Q&A: Replacement Mounting Brackets For Older Thule 6 Ski Carrier
- Q&A: Reattaching Broken Top Mounting Bracket to Thule Snowboard Carrier TH575
- Q&A: What Mounting Hardware Kit Do I Need for Thule Ski Rack on 2010 Audi Q5 Factory Aero Bars?
- Q&A: What Replacement Parts do I Need for My Thule Flat Top 724 Ski Carrier?
- Q&A: Barrecrafter Lower Foot Bracket Compatibility With Thule Mounting Hardware
- Article: How to Tie Down Skis and Snowboards to a Roof Rack
- Article: Best Bike Racks for Electric Bikes