Dimensions of Replacement Straight Threaded Shank for Old Style Swagman Original Bike Carrier
Updated 12/21/2021 | Published 12/20/2021
Question:
Is there a chance that I could get the drawing specs for this? Wall thickness, Hole diameters and actual placement/Location on the shank? Thanks in advance
asked by: Tony
Helpful Expert Reply:
I went out to the warehouse and measured the shank. The wall thickness is 3/16". The two smaller holes at the front of the shank are 1/2" in diameter and the larger rear holes are 5/8" in diameter. The overall length is 15" and the distance from center of threaded hitch pin hole to end of the shank is 13-1/2". As for hole placement on the shank, see the attached drawing.
(click to enlarge)
Product Page this Question was Asked From
Replacement Straight Threaded Shank for Old Style Swagman Original Bike Carrier
- Accessories and Parts
- Hitch Bike Racks
- Shanks and Adapters
- Shanks
- Swagman
more information >
Continue Researching
- Shop: Replacement Straight Threaded Shank for Old Style Swagman Original Bike Carrier
- Shop: Replacement 2" Shank for Swagman XC Series 2 Bike Carriers - Pre-2008
- Shop: Replacement Shank for Swagman XTC4 4-Bike Rack
- Shop: Replacement Shank for Swagman Dispatch, E-Spec, Escapee, Semi 4.0, and Quad 2+2 Bike Racks
- Q&A: Length and Metal Thickness Of the Replacement Shank for Swagman Dispatch & XTC4 Bike Racks
- Q&A: P315 Conversion Bar for Swagman XP Bike Racks
- Q&A: How Long is Replacement 2 Inch Shank for Swagman XC Series 2 Bike Carriers, # P249
- Q&A: Thule Replacement Wheel Cradle For Older Thule T2 Bike Rack
- Q&A: Is There A 2" Replacement Shank For A Yakima Quarter ROC Bike Rack
- Q&A: Comparing etrailer.com 3,200-Watt Generator to Champion Generator
- Q&A: Is there a Shorter Shank to Move Bike Rack Closer to Trailer when Using the Jack-It