Will the CE Smith I-Beam Clamps Fit on a 4 Inch Wide Trailer I-Beam
Updated 06/20/2013 | Published 06/18/2013
Question:
how wide a I-beam flange will these work on, mine is 4in. wide
asked by: Rick S
0
Expert Reply:
Technically, you are only limited by the size of the nut and bolt. A longer bolt used would mean you could go to a larger I-beam. With the included hardware the minimum I-beam width is 2-1/2 inches and the maximum is 4-1/2 inches. I made a video showing this for you.
expert reply by:
Michael H
0
Product Page this Question was Asked From
CE Smith I-Beam Clamps for Boat Trailers - Galvanized Steel - 2 Sets
- Boat Trailer Parts
- I-Beam Clamp
- CE Smith
more information >
Continue Researching
- Q&A: Is The Power Mountain Jack A Single Or Dual Piston Jack?
- Q&A: Overall Weight and Height of Powerbuilt Unijack Bottle Jack with Built-In Jack Stand
- Q&A: What is the Angle of the CE Smith Roller-Style Guide-Ons for Boat Trailers
- Q&A: Weight Capacity And Parts Needed For Modifying Boat Trailer For 26 Ft Regal Commodore
- Q&A: Dimensions of Upright Included with CE Smith CE27648 Guide Ons
- Q&A: Which Size Post-Style Guide-Ons Should Be Used On 2009 Century 2001 Boat Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Is there a 6 Foot Long Boat Trailer Bunk Board Kit
- Article: Trailer Lighting Requirements
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure