Is The Cotter Pin Removable On The Lippert Slide Out Motor 383897

Question

Question:

Is the pin removable ? I require a Lippert 383897 that uses two bolts and the only difference I can see on your video is the pin on one side of the drive shaft.

asked by: RK

0

Expert Reply:

I spoke with Lippert and they confirmed yes, the cotter pin in the drive shaft on the Replacement Gear Motor Assembly for Lippert Slide-Out # LC368446 is removeable.

expert reply by: Bryce D

0

Answer 1

To replace your defective Power Gear 130-1305 RV Slide-Out motor, you'd use the LCI #LC368446. I have attached a link below.

view full answer...

Answer 2

There is a trick to disengaging the brake. You would remove power from the motor. Then you will squeeze the two prongs within the rubber handle. You will either press down on the handle and turn, or you will squeeze handle, pull up and turn to…

view full answer...

Answer 3

I spoke with Lippert and based on the numbers you provided the Replacement Gear Motor Assembly for Lippert Slide-Out #LC368446 would be the correct replacement motor. I was not able to get dimensional drawings for this specific motor for you to…

view full answer...

Answer 4

If you wanted to make your 12 volt power circuit turn off when the vehicle is turned off you could install the isolation solenoid part #PK5231201 on the circuit. You'd need install the circuit to the outside posts and then for the center pin…

view full answer...

Answer 5

Lippert Components has confirmed that the Replacement Gear Motor Assembly for Lippert Slide-Out #LC368446 is the correct replacement for a Power Gear 130-1305 slide out motor.

view full answer...

Answer 6

Hello Cherry. To replace your Dometic Duo-Therm Quick Cool AC Unit I recommend the Advent Air #ACM150. This is made to be directly compatible with your existing Dometic AC system. You'll just need to remove the cover to your air distribution box…

view full answer...

Answer 7

I reached out to Lippert and found that the correct replacement for your Power Gear Slide out motor 524065 is the Replacement Slide Gear Motor Assembly for Power Gear Slides #LC387738. Thank you for the pictures, it makes it way easier to find the…

view full answer...

Answer 8

A faulty mechanical brake on your Slide-Out Motor #LC130057 could indeed be what is leading to the slide-out creeping out after being closed in, however my contact at Lippert said the more common cause has to do with the gear packs. It's possible…

view full answer...

Answer 9

Thank you so much for the info and the pictures! According to my research it looks like your Cummins Onan RV Generator uses a 3/8" NPT Female fitting so you'll need a hose like part #100040-144-MBS. I have attached a link to all of our hose…

view full answer...

Answer 10

In order to find the correct slide out motor for your 2005 Fleetwood Bounder Motorhome you'll need to first check your current motor for identifiers. Each motor will have a tag on the motor section and gearbox section that we can use to identify…

view full answer...

Answer 11

We do indeed have the replacement slide motor assembly you're looking for, from Lippert. The correct replacement for your Power Gear 522176 is #LC383745.

view full answer...

Answer 12

I spoke with Lippert and the only correct replacement for a PowerGear Motor #1010000010 is the PowerGear RV Above Floor Slide-Out Motor Item #LC368417.

view full answer...

Is The Cotter Pin Removable On The Lippert Slide Out Motor 383897

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching