Which Direction Does Awning Roller Need to Turn When Winding for Install
Published 10/25/2021
Question:
which way to turn the roller bar for tension on the slide out
asked by: Angel M
0
Expert Reply:
When winding awning rollers like the Solera RV Slide Out Awning part # LCV000163285 you wind them towards the RV. So like if the roller was on the ground the direction you'd roll the tube would be the direction that would roll the tube towards the body of the RV. This puts tension in the roller in the direction that allows the fabric to be held tight when the awning is out and then will roll itself back up as the arms close.
You'll want to roll the tube between 12 and 16 times to get the proper tension.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Solera RV Slide-Out Awning - 79" Wide - White
- RV Awnings
- Slide-Out Awnings
- Extends 4 Feet
- 6-1/2 Feet Wide
- 74 Inch Wide
- 75 Inch Wide
- 76 Inch Wide
- 77 Inch Wide
- 78 Inch Wide
- 79 Inch Wide
- White
- Solera
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Adding Slide Topper to Slide Out That Has an Awning - Is there room?
- Q&A: Slide Topper that Fits Flange to Flange Dimension of 79 inches
- Q&A: Replacement Leaf Springs for 2022 Grand Design Solitude With 7k Axles
- Q&A: How Many Times to Wind Solera Slide Topper for Proper Tension
- Q&A: How to Test Progressive Dynamics 4500 Converter to See if it Needs to be Replaced
- Q&A: How to Calculate Measurements for Solera 8' Slider # LCV000168106
- Q&A: Slide Topper Recommendation for Flange Width of 74 inches
- Article: Double-Eye Trailer Suspension System Review
- Article: What Is Flat Towing and How to Ditch the Trailer
- Article: How (and Where) to Connect an RV Propane Grill
- Article: No Missteps Here: Best Camper and RV Steps (2022)
- Article: Trailer Wiring Diagrams