Instructions On How To Replace Rubber Boots On A Tow Bar

Updated 10/12/2021 | Published 10/11/2021

Question:

How do you install the new rubber boot to the tow slide bar? I have a Remco tow bar.

asked by: Ron

Expert Reply:

To install the Replacement Rubber Boots for Curt Rambler Tow Bar # C25WR for your tow bar, you will want to start by cutting the zipties on either end and removing the old boot. Then you'll want to fully extend the leg and clean it with the silicone spray. Next, remove the bolt holding the triple lug on at the end of the tow bar. Then, carefully stretch the boot over the bar where the lug was attached and slide the boot down where it sits up against the release latch assembly, and secure that end with a zip tie. Finally, pull the leg out and apply white lithium grease to the inner leg and actuate the release handle; Align other end of the boot in place and zip tie.

When you're finished, you'll want to repeat the process for other leg.

expert reply by: Bryce D