Wire Gauge To Use for LED Work Light - Flood Beam - 780 Lumens
Published 09/23/2021 >
Products Featured in This Question
Question:
What would be the recommended wire gauge to run these lights approximately 20ft from the power source? Thank you.
asked by: Chad
0
Expert Reply:
I recommend using 14 gauge wire part # DW02422-1 to hook up the LED Work Light - Flood Beam part # UCL24CB to a power source up to 20' away. If you go any further you'd have to switch to 12 gauge. You can references these wire gauge charts easily online as well.
expert reply by:
Conner L
0
Product Page this Question was Asked From
LED Work Light - Flood Beam - 780 Lumens - Post Mount - Black Aluminum - Square - Qty 1
- Work Lights
- Flood Lights
- Work Lights
- Exterior Lights
- Square
- Pedestal Mount
- Flood Beam
- LED Light
- White
- Optronics
more information >
Continue Researching
- Q&A: Does MORryde GooseTech Have Vertical Movement
- Q&A: Which GooseTech Gooseneck Adapter Fits 2026 Alliance Avenue 32RLS
- Q&A: 2-1/2 Inch Weight Distribution Shank for a EAZ-Lift Weight Distribution System
- Q&A: Parts Needed To Convert An EZ Loader Boat Trailer From Surge To Electric Brakes
- Q&A: What is the Best Grease for Trailer Bearings
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Q&A: Correct Gen-Y Hitch 5th Wheel to Gooseneck Pin Box for 2024 Brinkley Z2900
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)

