What Size Wrench for Center Bolt of Dexter Tandem-Axle Trailer Equalizer Kit HAP-258-03
Published 09/16/2021
Question:
I have a Maxxd trailer with a slipper suspension and 7 K dexter axles. What is the size socket needed for the large center nut on the shackle bolt with the grease zero? I have a 1 1/4” wrench and it wouldn’t fit but close. Is it 1 1/2”. If so I will need to buy. Thanks!
asked by: Mark R
0
Expert Reply:
For heavy duty hex bolts that are 3/4 inch like what come with the # HAP-258-03 the correct wrench/socket size is 1-1/4 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter Tandem-Axle Trailer Equalizer Kit for 2-1/2" Slipper Springs - 24-5/8" Equalizers
- Trailer Suspension Parts
- Standard Equalizer
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2-1/2 Inch
- 24-5/8 Inch Long
- Tandem Axle
- Dexter
more information >
Continue Researching
- Search Results: gooseneck coupler
- Shop: Equalizer Suspension Bolt with Locknut - 5-1/4" Long
- Q&A: Replacement Equalizers For 2-1/2" Slipper Springs Mounted To 10,000LB Dexter Axles
- Q&A: Upgrading to Air Bags on a Food Truck Trailer
- Q&A: How To Find Correct Replacement Equalizer for Take 3 Trailer
- Q&A: Reverse Lights for 2018 Ranger Bass Boat Trailer
- Q&A: Replacement Dexter Equalizers for 2-1/2
- Q&A: Option For Replacing Tie Down 46304 Cailpers
- Q&A: Replacement For TDE LP75 Disc Brake Actuator
- Article: Most Popular Wheel Bearings
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Measure a Trailer Axle