Bulldog 4 Pin Rocker Switch Not Powering Badlands Winch

Published 09/16/2021

Products Featured in This Question

In/Out LED Rocker Switch For Bulldog Winch - 4 Pin - White

(19)

$18.99

Bulldog Winch OE Replacement Contactor - 200-Amp Powersports

(3)

$45.99

Question:

I ordered this switch as a replacement for a Badlands Wench Model 68146 its got a few years on it mounted on an EZGO Workhorse. Its not working and I think maybe Ive ordered the wrong switch. The original momentary rocker switch had 4 pins power in from battery, ground in from battery, power to winch out, power to winch in. I have tested to be sure my power from battery is good and it is. If I connect power in from battery to wench out and at the same time connect ground to power wench in, the wench correctly winds out. If I connect power from battery to wench in and at the same time connect ground to wench out the wench correctly winds in. When I install the switch #20261 the light powers on but I get no movement of the wench when the switch is pressed. Can you recommend the proper switch for this application?

asked by: Thomas D

Expert Reply:

The In/Out LED Rocker Switch For Bulldog Winch - 4 Pin # BDW20261 should work just fine for your Bandlands Winch Model 68146. You will also want to double check that you have the wires going to your switch as follows:

Terminal 1: Is power out from your winch
Terminal 2: Is your 12v power
Terminal 3: is your winch power in
Terminal 4: Is your ground

Ensure your ground connection is clean and not obstructed by debris or rust.

I did contact Bulldog, and they explained that if you're running a bigger winch directly to the switch it will not work because it is overloading the switch. If you are running a heavier winch you would need to have a contactor like # BDW20113 wired in. Alternatively, if you are running a smaller winch, you can use the switch in place of the hand controller.

If you have any further questions, I'd be glad to assist.