Removing Rivet of Frame Arms of Thule Revolver to Replace Wheel Cradle
Updated 08/09/2021 | Published 08/08/2021
Question:
Its time for me to change the cradle assemblies on my 964 Revolver. Just forward of the pin keeper V there is a rivet which precludes the removal of the drivers side cradle assemblies. Can I simply drill that rivet out? What is the function of this rivet? Is it simply to prevent the pin keeper V from sliding aft? If it is OK to drill out this rivet, what do I replace this rivet with size, length and material?
asked by: Bob N
Expert Reply:
You will need to drill out the rivet and then you can either put in a new rivet based on the hole size or you could put in a bolt that's appropriately sized. You may find that it's not needed at all. A lot of people leave it off.
Product Page this Question was Asked From
Replacement No Sway Cage for Thule Ridgeline and Revolver
- Accessories and Parts
- Hitch Bike Racks
- Anti-Sway Parts
- Cage
- Revolver
- Thule
more information >
Continue Researching
- Q&A: Recommendations For Replacement Thule Sway Cage and Cradles
- Q&A: How Many Thule No Sway Cage Parts Are Needed Per Bike?
- Q&A: Replacement Cradle Compatible for Wider Bikes
- Q&A: Correct Replacement Cradles for Yakima SwingDaddy Bike Rack
- Q&A: How to Install the Anti-Sway Cages of the Thule Stay-Put Cradles for a Thule Bike Rack
- Q&A: Availability of Replacement Parts for Thule Helium Pro
- Q&A: Wider And Flatter Replacement Cradle Option For A Thule Roadway 4-Bike Carrier