How is the Installation Hardware of the Curt Hitch # C12115 attached to a 2011 Buick LaCrosse
Question:
it looks like the bolts go through the rear frame members. Do you have to go through the trunk or do the bolts go over the frame member from underneath the car?
asked by: Fred B
0
Expert Reply:
The installation bolts for the Curt Trailer Hitch # C12115 that you referenced do go through the frame rails. To get the bolts through the frame they will need to be fishwired into place. You would not need access anything from the trunk of your 2011 Buick LaCrosse.
I attached an FAQ video on fishwiring for you to check out. I also attached a copy of the installation sheet for this hitch for you to check out.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Hitch that Fits 2013 Chevy Malibu LT
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Concealed Cross Tube Hitch Recommendation For 2019 Chevy Impala Premier
- Q&A: Recommended Trailer Hitch For 2019 Chevy Impala That Has The Best Ground Clearance.
- Q&A: Troubleshooting Installation of Curt 12115 Trailer Hitch Receiver
- Q&A: E-Bike Rack Recommendation for 2015 Chevy Impala
- Q&A: What is the Difference Between Class 1 and Class 2 Hitches for the Scion XB
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Which Hitches are Made in the USA
- Article: How to Install a Trailer Hitch
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Trailer Hitch Receiver Sizes