How Does Optronics Clearance Light MCL-91AK Wire to Two Wire Trailer
Published 07/07/2021
Products Featured in This Question
Question:
How do you wire this light to a 2 wire system. My original lights have black and white wires. How does this light connect to this type of wiring?
asked by: Justin H
0
Expert Reply:
You'd wire the # MCL-91AK by using the bracket the part # A91BB and the single wire part # A91LW. You'd run the power for the light to the single wire and then run the ground wire you have to the mounting hardware of the bracket as it is designed to ground through it.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
ThinLine Mini LED Side Marker or Clearance Light w/ Bracket - Submersible - 3 DIodes - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 2-1/2L x 1-3/16W Inch
- Amber
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Switch for Hopkins Breakaway Kit
- Q&A: Selecting a Replacement Trailer Jack for a Fulton 2228
- Q&A: Replacement Leaf Springs For a 2007 Feetwood Redline 33 Toy Hauler Travel Trailer
- Q&A: LED Lights for 1991 Ranger Boat Trailer
- Q&A: Who Makes The Best Quality Trailer Bearings?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended 7-Way Wiring Harness for a 2019 Subaru Outback Wagon
- Q&A: Recommended Center Cap for a Aluminum AM03 Series Black Machined Trailer Wheel
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How to Measure a Trailer Axle
- Article: How to Accurately Measure Trailer Leaf Springs