Replacement 12 inch and 8 inch Keel Rollers for Boat Trailer
Updated 05/25/2021 | Published 05/22/2021
Products Featured in This Question
Question:
Hi - we have a galvanized trailer with 4 rollers 1 12inch roller rear and 3 8inch rollers moving forward from the rear. The holders for the rollers are in great shar and galvanized so, wed just need the replacement pins and rollers. The trailer is primarily used in saltwater rinsed with fresh water after each use and wed like to replace the rollers with something that will hold up. Our boat is a 24foot Limestone 24 deep V. Which rollers and pins would you recommend? Thanks
asked by: Norm L
Expert Reply:
For the 12 inch roller you'd want the part # CE29519 which is made from a very durable PVC that is non-marking. For pins and a shaft you'd just need the part # CE10727A.
Then for an 8 inch setup that comes with the mount as well you'd want the part # CE10453G and you'd be set.
Product Page this Question was Asked From
CE Smith Keel Roller for Boat Trailers - PVC - 12" Long - 5/8" Shaft - Amber
- Boat Trailer Parts
- Rollers
- Keel Roller
- 3-1/2 Inch Diameter
- PVC
- 11-3/4 Inch Long
- Fits 5/8 Inch Shaft
- CE Smith
more information >
Continue Researching
- Q&A: How Does the CE Smith Single Axle Trailer Fender Attach to the Trailer?
- Q&A: How to Determine Fit of 12" CE Smith Keel Roller for Boat Trailers
- Q&A: What Holds Wobble Rollers onto a Trailer
- Q&A: Recommended Replacement Boat Trailer Roller with Wobble Function
- Q&A: Load Capacity of Yates V Keel Roller
- Q&A: Replacement Rollers For 1965 Vintage Boat Trailer
- Q&A: Comparing PVC, TPR, and Polyurethane Boat Rollers
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Accurately Measure Trailer Leaf Springs