What is the Weight Capacity of the Thule Goalpost Hitch Mounted Load Bar?

Question

Question:

How much weight can it hole fully extended on a front mount hitch holding two kayaks half on roof and half on goal post. I see it said 165 but is that fully extended

asked by: Dwight B

0

Expert Reply:

The Thule Goalpost Hitch Mounted Load Bar has a maximum weight capacity of 165 pounds when fully extended.

expert reply by: Bob C

0

Lyle

6/29/2024

What is the total height. I need 70 inches from front hitch to clear cab

Reply

Answer 1

Unfortunately we don't have any roof racks that are confirmed to fit your 2014 Toyota Sienna other than installing them onto the existing rails. However, I may have another option that could work for you. You can use a hitch mounted load extender…

view full answer...

Answer 2

What you are going to want to give you more stability for your kayak rack is the Rhino-Rack T-Load Hitch Mounted Load Bar #RTL002 installed in a 2 inch hitch on your 2016 Subaru Outback Wagon like part #75673. This will give you a third crossbar at…

view full answer...

Answer 3

The longest load extender is the Erickson Big Bed Load Extender for 2" Hitches - 400 lbs #EM07600. This is 52-1/2" long x 48-1/2" wide. For a 16 foot canoe, there really isn't a good solution for such a short bed without going onto…

view full answer...

Answer 4

Yes, the Rhino-Rack T-Load #RTL002 can be used on the front of your 2016 Nissan Frontier with the Draw-Tite Front Mount Trailer Hitch Receiver part #65075 in order to haul your kayak. In addition to the T-Load, you also need a connection point on the…

view full answer...

Answer 5

Because of the overhang from a 5th wheel trailer the best solution for transporting a couple of kayaks while towing is with the combination of a single bar rack for the cab and a front-mounted load extender that installs into a front-mount hitch. For…

view full answer...

Answer 6

Other than the front mount hitch for your 2015 Ford F-350 such as #65049 you will also need at least a single roof rack bar and a carrier of some kind to hold the canoe. This would be in addition to a support used in the front mount hitch. For a…

view full answer...

Answer 7

In order to haul a 17' long aluminum canoe and tow a trailer with your 2018 Chevrolet Silverado 2500HD, I have two options for you. The first option would be to place part of the canoe on the roof and the other part on a t-load carrier at the…

view full answer...

Answer 8

There's no reason you couldn't install the Rhino-Rack T-Load #RTL002 in the front hitch of a vehicle for loading paddle boards. The adjustable height range of this product is 42 to 64 inches so you might compare that to the amount of height…

view full answer...

Answer 9

Hey Tony, The etrailer Hard Tonneau Cover #e55DR does not come with a built in lock, but if you lock the tailgate of your truck then no would would be able to open the cover without damaging it or the tailgate.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

I have a solution for you, but a ladder rack may not be the answer. While we have the DeeZee Invis-A-Rack Folding Ladder Rack #DZ951601 for 6 foot beds or #DZ951551 for 5 foot beds, we do not have a tonneau cover that will work with this ladder rack.…

view full answer...

Answer 12

Hey Ron! It sounds like you need the Replacement Storage Pin for Demco and etrailer Tow Bars item #DM23VR. This works with all of the etrailer XHD Non-Binding Tow Bars like item #e94ZR. I attached a picture below where I circled the pin which item…

view full answer...

What is the Weight Capacity of the Thule Goalpost Hitch Mounted Load Bar?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching