Installation Instructions for Single Slide Out Momentary Switch
Updated 04/09/2021 | Published 04/07/2021 >
Question:
Where does the extend and retract wires go on this switch?
asked by: Debbie A
0
Expert Reply:
When installing the Labeled Single Slide-Out Momentary Switch - On/Off/On - White # 37212075 you will want to follow the attached wiring diagram. This is a 5 wire switch, where each motor function will have a positive and negative wire, and the general power to the switch will have it's own pin.
The retract function would be on the left side pins and the extend function would be the right side pins.
expert reply by:
Erik B
0
Product Page this Question was Asked From
Labeled Single Slide-Out Momentary Switch - On/Off/On - White
- RV Slide Out Parts
- Controller Parts
- Switch
- White
- JR Products
more information >
Continue Researching
- Q&A: SoftStart for Furrion Chill RV AC Unit 13.5k BTU Unit
- Q&A: Replacement Converter for 45 Amp Magnetek 6345
- Q&A: Wiring In A Furrion Arctic RV Refrigerator
- Q&A: Determining The Correct Replacement Entry Lock For A 2008 Fleetwood Bounder 38V
- Q&A: Does Regulator for Dual Propane Tanks Work With a Single Tank
- Q&A: Soft Start Recommendation for 13K Bu Furrion Chill HE AC Unit
- Q&A: Recommended Replacement For A Hight Pointe RV Microwave Model # EM925RWW


