Recommended Solution to Fight Sag on Nissan Quest with Coil Springs When Carrying Motorcycle
Updated 03/26/2021 | Published 03/25/2021 >
Products Featured in This Question
Question:
I have a 2013 Nissan Quest with your Curt III hitch on it. It sits pretty low. I would like to get a motorcycle hitch mount carrier for my dirt bike—but I’m concerned it will be too much weight for the set-up. I don’t totally understand HW and could use some guidance. If the hitch can take the weight—Will it make the rear sag so much I won’t have any clearance to leave angled parking lots?
asked by: Zach S
Expert Reply:
The tongue weight (or hitch weight) is the maximum amount of weight that the frame of the vehicle can withstand without being damaged. You'll also always be limited to the lowest rated component in your towing setup, so even if your hitch says maximum 500-lbs tongue weight, but the vehicle is only rated for 350-lbs (which my research indicated), you will be limited to that 350-lbs. This means that any carrier and motorcycle must have a combined weight of less than 350-lbs.
When it comes to the sag, there's a good chance that the vehicle will sag a bit with 350-lbs on the back of it, so you might want to consider using the Sumo Springs Coil Helpers # CSS-1195R to help fight some sag. These won't give you more carrying capacity, but they do help fight sag that can occur with a motorcycle carrier on your hitch.
If you don't have a motorcycle carrier I recommend the Ultra-Fab Motorcycle Carrier for 2" Hitches - 500 lbs # UF48-979033 because it only weighs 50-lbs, so it's going to allow you to carry a motorcycle that weighs up to 300-lbs. This is one of the lightest weight carriers we have available and will work on a Class III hitch with a 2" receiver. Pairing these 2 together would be a good idea, and while you're still going to have some ground clearance issues because of the limited ground clearance of your vehicle when unloaded, it's going to give you some extra help that should help reduce incidents where you bottom out.
I've linked some review videos of these parts for you to check out, but outside of using a smaller trailer, this would be the best way to reduce sag and still take your bike with you wherever you needed.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Ball Mount Kit, Trailer Hitch, and Wiring Harness for a 2010 Dodge Challenger
- Q&A: Availability of Replacement Hitch Install Hardware for Curt Hitch 13465
- Q&A: Recommended Hitch for a Bike Rack on a 2010 Dodge Challenger
- Q&A: Recommendations for Reducing Trailer Sway while Towing with a Dodge Magnum
- Article: Trailer Wiring Diagrams
- Article: How to Install a Roof Rack
- Q&A: How to Determine Which Ball Mount Will Have Enough Rise for Curt Hitch on a 2005 Chrysler 300c
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Should a Spray-In Bed Liner be Sprayed in Before or After Gooseneck Hitch Install on 2017 Ford F-350
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)



