What Would Amperage Draw be for 14 Optronics Clearance Lights MC11RB
Updated 01/01/2021 | Published 12/30/2020
Question:
I would like to run 14 of these 7 each side on my 1996 Dodge Ram 3500. Is that too much of a draw on the running light circuit ?
asked by: Mike B
0
Expert Reply:
Each one of the Optronics Mini Trailer Clearance lights part # MC11RB draws .4 of an amp so if you had a total of 14 of these they would put a draw of 5.6 amps on the circuit. That's pretty reasonable for a running light circuit so you might check to see but I'd suspect you'd be fine.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Optronics Mini Trailer Clearance or Side Marker Light - Incandescent - Rectangle - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 3-3/16L x 1W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Brake Controller Installation on 2007 Chevy Tahoe
- Q&A: Ford Integrated Brake Controller Not Working Well with Trailer with Electric/Hydraulic Setup
- Q&A: Replacement Trailer Clearance LED Lights with 2 3/4 Mounting Hole Spacing
- Q&A: Can I Add Two Side Marker Cameras To Furrion Vision S+ Camera System?
- Q&A: Is Trailer Tire Size 18.5 x 8.5 x 8 the Same as Trailer Tire Size 215/60-8
- Q&A: Replacement Parts For Blue Ox Alpha 2 Non-Binding Tow Bar # BX7380
- Q&A: Troubleshooting Surge Brakes Locking up When in Reverse
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Best Boat Trailer Jacks