Should you Re-install the DeeZee Tailgate Assist if it was Installed Upside-Down
Updated 12/14/2020 | Published 12/10/2020
Question:
I seem to have installed the assist shock absorber upside down, with the skinny part on the down side. Should this mater? It seems to function properly but would it be any better the other way? It doesnt want to come out easily and Im afraid to force it out of the ball socket.
asked by: Mick K
Expert Reply:
If you installed the DeeZee Tailgate Assist, part # DZ43204, upside-down, then I recommend removing it and installing it rightside-up. Though it seems to be working properly now, there may be some unforeseen complications later on, so it's better to be safe than sorry.
As for forcing it, don't worry about this too much. It's a snap-in-place assembly, so there isn't a risk of damaging the components.
Product Page this Question was Asked From
DeeZee Tailgate Assist Custom Tailgate-Lowering System for Pickup Trucks
- Lift Supports
- Vehicle
- Tailgate Assist
- DeeZee
more information >
Continue Researching
- Q&A: What is the Difference Between the Blue Ox Patriot BRK2019 & BRK2022?
- Q&A: Can Truck with Firestone Ride Rite Air Bag Kit Installed be Lifted By Frame
- Q&A: Replacement Actuator for Tie Down TDE LP8000
- Q&A: How to Remove the Curt Pop-In Ball # C60601 with Broken Release on a 2016 Ram
- Article: Trailer Wiring Diagrams
- Q&A: Where is Brake Controller Wiring on 2023 Ford Ranger
- Q&A: Replacement for 3-Steps on a 2010 Jayco Jay Flight Travel Trailer
- Q&A: Ram Truck Factory Puck System for 5th Wheel Hitches
- Article: Rooftop Cargo Carriers
- Article: What is the Best Trailer or RV Storage Cover
- Article: How to Measure for Trailer Hitch Drop