Troubleshooting Slide Topper That is Too Tight on RV Slide Out
Updated 10/19/2020 | Published 10/16/2020
Question:
I installed this topper and looks great, but when I ran the slide out the tension prevents the top portion of the slide from sealing. How can I adjust the tension so I still get a full seal?
asked by: Ian W
0
Expert Reply:
How many times did you wind the roller of the slide topper # LCV000168106 when you installed it? Solera recommends 12 to 16 turns so you might try backing down to 12 if you had higher than that so that your slide will seal properly.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Solera RV Slide-Out Awning - 91" Wide - Black
- RV Awnings
- Slide-Out Awnings
- Extends 48 Inches
- 7-1/2 Feet Wide
- 86 Inch Wide
- 87 Inch Wide
- 88 Inch Wide
- 89 Inch Wide
- 90 Inch Wide
- 91 Inch Wide
- Black
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Will Solera Awning Attach to Brackets on Slide Out of 2020 Forest River Salem FSX Platinum 178BHS
- Q&A: Correct Solera Slide Topper For 86 Inch Wide Slide Out
- Q&A: How To Select The Right Awning Size For Slideout
- Q&A: Can The Furrion LC74DX Thermostat Control The Heater As Well As The AC Unit?
- Q&A: Can I Slide Topper be Used on a Slide Out with an Awning?
- Q&A: Can A Slide Topper Awning Be Installed On a Slide Out with Standard Awning Already Attached
- Q&A: Solera Slide-Out Awnings for 88", 122", and 146" Slide-Outs
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Repair an RV Roof
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Trailer Wiring Diagrams