Weld-On Mounting Bracket and Hardware Dimensions for Fulton Swing-Up Trailer Jacks

Question

Question:

What are actual dimensions of this plate overall L x W and distance between the threaded holes? A photo w/ the dimensions overlayed on the plate would be great like you did on the smaller plate.

asked by: Waterman S

1

Helpful Expert Reply:

The Fulton mount # F500276 hole to hole length center on center is 5-1/2 inches and the hole to hole width center on center is 4-1/2 inches. The overall is 6 by 5 inches.

The bolts included are 7/8" with threads that are 16 course.

expert reply by: Jason S

1

click to enlarge

Answer 1

The mounting holes on the Fulton XLT Bolt-Thru Swivel Trailer Jack part #F141133 are spaced 5-1/2" apart left to right as you can see in the attached photo.

view full answer...

Answer 2

The #SP-210275 you were looking at is for a 3500lb axle and is 27" long measured from center of spring eye to center of spring eye. This is the correct spring for your trailer based on the measurements you provided. The next shortest spring…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Answer 6

Thanks for the pics Kemo, they really helped! The CE Smith Single Axle Trailer Fenders #CE19504-2 are larger than what you currently have and use a different mounting style. Based on your setup, the CE Smith Fenders wouldn’t bolt onto your existing…

view full answer...

Weld-On Mounting Bracket and Hardware Dimensions for Fulton Swing-Up Trailer Jacks

Continue Researching