Replacing 5th Wheel LED Marker Light Not Working
Updated 10/07/2020 | Published 10/06/2020
Products Featured in This Question
Question:
Can the inside be replaced or does the whole light need to be replaced?
asked by: Steve K
0
Expert Reply:
The Miro-Flex Thinline LED Trailer Clearance or Side Marker Light - Submersible - 4 Diodes - Amber Lens # MCL63AB can't have the inside replaced. You would need to replace the entire LED light. Before replacing the light, you want to make sure you don't have a wiring issue. You can test the light with a 12v battery, or you can test the wires using a circuit tester like # PTW2993.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Warm White 4-1/4" Diameter Puck Light
- Q&A: Trailers Right Tail Light Stays on Even While Unplugged
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can I Use a 4 Way Vehicle Connector with 7 Way Adapter and the Curt Echo Brake Controller?
- Q&A: Will Timbren's Work with a B&W Gooseneck Hitch on a 2012 Ford F-150
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer