Bolt Pattern and Mounting Plate Dimensions for Kwikee 40 Series Steps
Updated 10/06/2020 | Published 10/05/2020 >
Question:
The diagram on your site shows the mounting plate 25-2/3inch wide and the mounting bolt pattern as 26. This is obviously not accurate. The bolt pattern can not be wider than the plate. I need the correct measurements. I have a 40 series that I am replacing and the plate is 24inch wide and the bolt pattern is 12inch deep and 20-1/2inch wide. All the other demotions you have listed match. Please provide the accurate plate dimensions and bolt pattern. Thanks!!!!
asked by: John D
Expert Reply:
In regards to the Kwikee 40 Series Electric RV Steps like part # LC3726891, the step mounting plate is 25-3/4" wide x 14-3/4" deep and the bolt pattern is 20.5" wide x 12-7/8" deep. I confirmed this with Lippert for you and have attached a photo below.
Product Page this Question was Asked From
Replacement Steps, Motor, and Switch for Kwikee RV Electric Steps - 40 Series - 24" Wide
- RV Steps
- Motorhome
- Electric Step
- 24 Inch Wide Step
- 24-1/4 Inch Wide
- 2 Steps
- 8 Inch Drop/Rise
- Steel
- Kwikee
more information >
Continue Researching
- Q&A: Does Replacement Lippert Motor LC183058 Come with Instructions
- Q&A: What Lippert Powered Steps are on Coachmen Mirada 35BH
- Q&A: What Replacement Steps do I Need for My 2008 Newmar 2901 with Part Number 124013P?
- Q&A: Recommended Lift Kit for Leveling 5th Wheel Trailer When Pin Box and Hitch Adjustments are Maxed Out
- Q&A: Troubleshooting Camco Rhinoflex Sewer Hose that Came Apart at Locking Ring
- Q&A: Replacement Stereo Recommendation for Jensen VR209TP
- Q&A: Recommended Replacement for Jensen VR209TP RV Stereo

