Can Ignition Wire of Superwinch LT2000 Run to Main Power Wire
Updated 09/28/2020 | Published 09/24/2020
Question:
I saw a reply from Michael h on wiring the red ignition wire to a power source if I’m putting an atv winch on a boat trailer. Can I wire it to the red power terminal on the solenoid.
asked by: Jeff
0
Expert Reply:
The ignition wire of the # 1120210 is an activation circuit that normally is used when installing on an ATV to tell the winch the ATV is on and the winch is powered up. In a boat trailer install situation like you mentioned you could run this circuit to the same place as the main power wire and it will work just fine.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Superwinch LT2000 ATV Winch - Wire Rope - Roller Fairlead - 2,000 lbs
- Electric Winch
- ATV - UTV Winch
- Planetary Gear
- 1.0 HP
- 1001 - 2000 lbs
- 11 - 20 lbs
- Slow - 0 to 4 fpm
- Handlebar Remote
- Wire Rope
- Superwinch
more information >
Continue Researching
- Q&A: Recommended Electric Winch for Raising and Lowering a Pop Up Camper
- Q&A: Looking for an Electric Winch to Raise a Platform Into the Sacred Man Cave
- Q&A: 1,200 lb Electric Winch that Uses AC Power
- Article: How to Wire an Electric Winch
- Q&A: Where Does The Red Rocker Switch Wire Attach To When Installing SuperWinch LT2000?
- Q&A: Recommended Battery to Power an Electric Winch
- Q&A: Solution for Needing Replacement Hub with Bearings 12649 48548
- Q&A: Installation of the Remote for the Superwinch LT2000
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today