Mounting Bolt Pattern of 10 Inch Electric Drum Brake Assemblies

Updated 08/18/2020 | Published 08/14/2020

Products Featured in This Question

etrailer Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 3,500 lbs

(799)

$123.12

Brake Mounting Flange for 2-3/8" Round Axle

(27)

$26.93

#84 Spindle for 3,500-lb Trailer Axles - 1-3/4" Diameter

(129)

$85.85

Question:

I have a LOAD TRAIL trailer with 1 3/4 x10 brakes and 2, 3500 axles. Id like to up grade the brakes to 2 1/4 x10. I need to replace the drums and brake assemblies. I found the parts on your web sight. Hub Drum kit AKHD-550-35-EZ-K and Brake KIT AKEBRK-35 . The backing plate bolt spacing isnt listed can you tell me the spacing? Also can you confirm theses parts will fit my trailer? Thank you for all your help

asked by: Bob

Expert Reply:

The Electric Trailer Brake Kit - 10" - Left and Right Hand Assemblies - 3,500 lbs # AKEBRK-35 has a mounting pattern that is typical for 3,500 lb axles. The center on center horizontal measurement of the mounting bolts are 2-7/8 inches and diagonal center on center of 4 inches. You can see this with the mounting flange # 4-35.

I can't confirm the fit of the hubs on your trailer without knowing if the spindles on the axles are the standard length or not. The standard spindle length leading up to the stub (shaft length) is about 5 inches. This is the case for spindle # TRU84FR, which has an overall length of 11-1/4 inches and a stub length of 6-1/2 inches.

expert reply by: Jason S