What Size Tube Will Fit in the Clamp on CIPA Rearview Boat Mirror # CM11119
Updated 10/11/2012 | Published 10/10/2012
Question:
curious if the clamp on this mirror will fit onto a square 3/4inch tube.
asked by: Mike
0
Expert Reply:
I spoke with my contact at CIPA and found that the Rearview boat mirror, # CM11119, will fit on round or square tubes up to 7/8 inches thick so it will fit a 3/4 inch square tube.
expert reply by:
Michael H
0
Product Page this Question was Asked From
CIPA Rearview Boat Mirror - Convex Glass - Windshield Mount - 8" Long x 2-1/2" Wide
- Boat Mirrors
- Boat Mirrors
- Convex Mirror
- Clamp-On
- 8L x 2-1/2W Inch
- Black
- CIPA
more information >
Continue Researching
- Article: Boat Trailer Guides: Which are the Best?
- Q&A: Are Clamp-On Boat Mirrors Available for Sea Ray?
- Q&A: Determining If Surge Brake Actuator Has Lockout or If Brakes are Free-Backing
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Article: Frequently Asked Questions About Transmission Coolers
- Q&A: Can I Use the CargoSmart S-Curve Loading Ramp Set for a 1800 Pound SxS?
- Q&A: What Gauge are the Wires on Optronics Wishbone 5-Way Trailer Harness?
- Q&A: Black Rear-View Marine Mirror for Use on 1987 Nautique Ski Boat
- Q&A: Solution for Lost Key for Bauer Products RV Baggage Door Slam Latch
- Article: Trailer Tire Sizing
- Article: How to Measure Your Trailer Wheel Bolt Pattern