Procedure for Flat Towing 2007 Ford F-150 Behind Motorhome
Updated 08/06/2020 | Published 08/05/2020 >
Question:
How to tow my f150 . Do I just put in N ? Turn on switch ?
asked by: Rickey
Expert Reply:
The exact procedure will depend on which transfer case your truck is equipped with.
For a manual shift transfer case, you'd do as follows:
Release the parking brake.
• Turn the key in the ignition to the OFF position.
• Place the transmission in N (Neutral).
• Place the transfer case lever in N (Neutral).
• Do not exceed 55 mph (88 km/h) vehicle speed.
• The maximum recommended distance is unlimited.
• The vehicle must be towed in the forward position to ensure no damage is done to the internal transfer case components.
The transfer case N (Neutral) position overrides the transmission and puts the vehicle in neutral regardless of transmission gearshift lever position. The vehicle can move forward or backward. This position should only be used when towing the vehicle
If the truck has the electronic shift transfer case, the procedure is much more involved:
Release the parking brake.
• Turn the key in the ignition to the OFF position.
• Place the transmission in N (Neutral).
• Do not exceed a distance of 50 miles (80 km).
• Do not exceed 35 mph (56 km/h) vehicle speed.
• The vehicle must be towed in the forward position to ensure no damage is done to the internal transfer case components.
If a distance of 50 miles (80 km) or a speed of 35 mph (56 km/h) must be exceeded, you must disconnect the front (4x4 only) and rear driveshafts. Ford recommends the driveshafts be removed/installed only
by a qualified technician at an authorized dealer. See your authorized dealer for driveshaft removal/installation. Improper removal/installation of the driveshaft can cause transmission fluid or transfer case fluid loss, damage to the driveshaft and internal transmission and transfer case components.
In addition to the # BX2169 base plates you'd looked at, you'll also need a tow bar, base plates, a wiring harness, safety cables, a supplemental braking system and possibly a high/low adapter. I'd be happy to suggest some specific parts if you'd like.
I've linked to some articles about flat towing that you might find helpful.
Product Page this Question was Asked From
Blue Ox Base Plate Kit - Fixed Arms
- Tow Bar Base Plate
- Fixed Draw Bars
- Visible
- Blue Ox
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Video: DIY 2007 Ford F-150 Installation for the Curt Front Mount Trailer Hitch Receiver
- Q&A: Trailer Lights Not Fully Working on a Trailer Towed by a 2007 Ford F-150 with Factory Tow Package
- Q&A: Correct Replacement Braking Assemblies For AxleTech 12-GG
- Q&A: No Trailer Connection on Tekonsha P3 Brake Controller 90195 on a 2000 Toyota Tundra
- Article: Best Vehicles to Flat Tow Behind an RV
- Q&A: What Comes With Nighthawk All-Terrain Tow Bar for Blue Ox Base Plates
- Q&A: Parts Needed To Flat Tow A 2006 Ford F-150 XLT
- Article: Flat Towing Package for 2002-2004 Jeep Liberty
- Article: Must-Have Flat Towing Components
- Article: Can You Flat Tow a Ford Ranger?
- Q&A: Parts Needed to Flat Tow a 2015 Jeep Wrangler Unlimited Sport
- Q&A: Recommended Flat Towing Parts for a 2015 Jeep Wrangler w/ a Rock Crawler Bumper
- Article: Flat Towing Package for 1998-2006 Jeep Wrangler
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing




