Thread Tap to Use with Hitch Install Hardware for Curt Hitch C13073
Updated 07/28/2020 | Published 07/25/2020
Question:
are they the same size ? the bolts sent with my draw tite hitch seem bigger n dont fit.. i did clean em out too. thx.
asked by: Danny B
0
Expert Reply:
This is a very common issue. The issue is that the weld nuts are still dirty and need to be cleaned further or tapped so that your hitch hardware can install. We have the correct thread tap to use with the hitch # C13073 with the part # PTW8618.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Comparing Curt # 13195 and Draw-Tite # 75908 for 2017 Kia Sorento
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Caliper Mounting Bolt for Disc Brakes
- Q&A: Can I Swap Out My Kodiak Hub and Rotor for a Deemaxx Hub and Rotor?
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: Holiday 2025 | Best Gifts for RVing
- Q&A: Deciding Between The Curt And Draw-Tite Hitches For My 2021 Subaru Forester
- Q&A: Recommended Trailer Hitch and Wiring for 2011 Hyundai Santa Fe with Spare Tire Under Vehicle
- Q&A: Recommended Replacement For An Atwood G6A-8E RV Water Heater
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Q&A: How to Tell the Difference Between a 4-Bolt and a 10-Bolt 5th Wheel Hitch Mounting Rail
- Article: Dealer Spotlight - Taps Truck and Auto Accessories
- Article: How to Measure for Trailer Hitch Drop
- Article: Ball Mount Basics: Weight Capacity, Class, and Size