Are Inflation Valves Included with the AirLift 1000 Air Helper Springs for a 1995 Crown Victoria

Updated 09/05/2012 | Published 08/31/2012

Question:

Is there a airbags valve that I can go to a air pump and pump air in it on a 95 crown Vic for the airbags suspension

asked by: Roleisha

Expert Reply:

Yes, the AirLift 1000 Air Helper Springs, # AL60798, do come with inflation valves so you can fill the air bags at the location of your choosing. The recommended method for installing these air bags is using the tee. You will route an air line from each air bag to the tee and then one line to the inflation valve. This will ensure that your air bags are filled evenly.

If you think that the load in the rear of your vehicle will be uneven from one side to the other, then you can also install two inflation valves and not install the tee. This will allow you to fill each air bag independently and not allow the air to migrate from one bag to the other when a greater load is placed on only one side of your vehicle.

I have attached a link to the installation instructions for you to check out.

expert reply by: John H