Inside Diameter of the Replacement Manual Override Crank for Bulldog Powered-Drive Trailer Jacks

Question

Question:

I dont see the diameter of the hole or the slot width. Can u help me out.

asked by: Randall B

1

Helpful Expert Reply:

In regards to the Replacement Manual Override Crank for Bulldog Powered-Drive Trailer Jacks part # BD500203, the inside diameter of the hole is 1/2" and the dimensions of the slot can be found below.

expert reply by: Conner L

1

click to enlarge

Answer 1

It sounds like you're wanting a CAD of the Replacement Manual Crank Handle for Stromberg Carlson Electric Trailer Jacks #SC94VR. Unfortunately we don't have those but I can tell you that the crank handle fits the following Stromberg Carlson…

view full answer...

Answer 2

The Replacement Manual Override Crank for Bulldog Powered-Drive Trailer Jacks #BD500203 will be a fit for many jacks. The diameter of the socket is 7/8", it is about 1/2" deep, and the slit on the sides is 1/4" wide. If you can let me…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hey Katja, the Curt Echo Mobile brake controller part #C51180 would be your best option. This is a wireless brake controller and all it requires is a 7-way with the taillight functions and the 12 volt accessory circuit active and you'd be set. So…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

view full answer...

Answer 7

Hello, and thanks for getting in touch. The etrailer Electric Trailer Jacks #e55ZV and #e23ZV will hold up just fine in cold weather. The housing is designed to be water/weather resistant. It even has a manual backup option if you were to lose power…

view full answer...

Inside Diameter of the Replacement Manual Override Crank for Bulldog Powered-Drive Trailer Jacks

Product Page this Question was Asked From

Continue Researching